Ok, these two are very similar, both are standered hand puppets, two is slightly bigger then one obviously, and I did not get all the pictures taken with these two for some reason, so I am joining them together in the instructions on how I made them. First off this pic is from #1, and shows the basic design of the mouth which will be hot glued around the rim of the hard card board board starting with the top center of the board. I got the shape for the foam mouth peice by using the hard mouth piece to start off with then laying it on the foam you simply add abou an inch and a half to the bottom two sides going out from the hard mouth piece and then simply draw a curve up to the top of the hard mouth piece, this should give you a good mouth with pleny of room for your hand, and of coarse if you want the pod to be larger or taller just add to the inch and a half.
No comments:
Post a Comment